How can I connect my cable box, computer, and HDdvd player wirelessly to my projector?

My projector has the typical video inputs; VGA, RCA Video, S-Video, and something call a RS232 control port. I figure I could use the RCA video near the Cable TV box. I could pair the VGA beside my desktop or laptop, and the S-video with the HDdvd player.
I be wondering if I could connect all these components to a transceiver and convey them wirelessly, with impossible to tell apart quality, to a reciever and afterwards to my projector?


Answers:    Here is a much cheaper solution. The unit mentioned is over $600 and is designed for HDMI use.

There are several question I have, such as, what is the model of your projector? You do realize that you will not be getting true HD from your HD DVD player through an S-video cable, right?

The just connection on your projector i.e. HD capable is your VGA input. BUT, that does not tight-fisted your projector has a aboriginal resolution that is 720p or greater. More than likely, your projector is 1024X768, which *SOME REFER TO* as partially HD, because for true HD you need at lowest a 1280X720 native resolution. What a projector does that have native resolution of 1024X768 is down convert the HD signal to a lower resolution.

I utter all of that to say-so this, you need to evaluate how you are hooking up everything. I would suggest getting a addressee with component outputs, and afterwards get a cable which is component to VGA. This will allow your projector to receive adjectives signals at the highest plane the source can input (cable, HD DVD, etc.). You can get this type of cable on ebay. 25ft, 50ft, etc. Follow the contact below for a 50ft cable for under $30 bucks. I hold one and it works great!

Let me know your projector's model number and I can tell you what the home-grown resolution is. I cannot imagine it's an HD projector near no HDMI or component inputs, UNLESS it is an older projector. But almost every HD projector made surrounded by the past two years have HDMI or Component inputs.
Not to my best knowledge. Wireless HDMI nouns was annonced by Philips ($300) and some others - but I own not seen it hit the marketplace yet.

I found this element, but it is pretty expensive -
http://www.audio-discounters.com/ext-whd...
First off I hold to agree with the poster above in connection with the receiver near multiple inputs. What you want to do however is get a short VGA to component and the use container connectors to attach it to a long component cable. A 25' VGA to component would cost you $100 bucks. You can find the materials here.

http://www.cablestogo.com/product.asp?ca...

http://www.cablestogo.com/product.asp?ca...

http://www.cablestogo.com/product.asp?ca...

Secondly I must comment on the resolution portion of his answer. I don't know where he get the information but there are PLENTY of HD 720p projectors in need HDMI or Component. Just because it only have the VGA connectror does NOT mean it is not true HD. Not just that, but there is no such point as "half HD", newly 480p which is considered "Enhanced Definition TV". 1024 X 768 is just as HD as 1280 X 720.

weeder
Weeder is incorrect surrounded by saying that 1024X768 is a moment ago as much HD as 1280X768! That is like motto that 720p HD (1280X720) is as good as 1080p HD (1920X1080)....completly incorrect! On TV's the 1024X768 resolution is repeatedly advertised as HD, but it is not true HD. Advertisers are immediately making that distinction by putting "True HD" on their products.

The problem with 1024X768 is at hand are not enough vertical lines (1280 are needed) to support full HD. There are however adequate horizontal lines (720 are needed). So, some call the TV/Projector HD proficient because it has the facility to output enough horizontal lines of resolution. BUT, because it can't output plenty vertical lines, the TV/Projector has to convert the resolution lower to hold the 16:9 formatting that HD comes in. This usually give you a resolution of 1024X576 which is still better than standard definition TV.

This resolution can be referred to as 576p, which is not 720p! If you want true HD, you have to own at least 720p. That is the minimum resolution that broadcasters such as CBS, FOX, etc, broadcast within. Hope this helps!

The answers post by the user, for information only, CeQnA.com does not guarantee the right.



Related Questions :
  • Can i copy movies on blanck cd??
  • Do you hold to own a HDTV with1080P to capture the best picture from a Blu Ray player?
  • Blu-ray and HDvd?
  • How giant can the warmth be surrounded by my electronics cabinet?
  • My yamaha yst800 subwoofer have no nouns coming out. How can Icheck to see if it works?
  • Which is more High-definition : 1,DVD-Audio , or 2, SACD ?
  • What dvd extras are on the hero season 1 boxset? the middle-of-the-road dvd set and the hd dvd?
  • HDTV- electrics help- grill roughly component video plugs?
  • How to stability Speaker's Ohms (Ohm)?