I just replaced dlp lamp and it seems to flicker.Any suggestions?
Answer:
Your picture kinda pulses eh?
Yes, pull out the lamp, get a flashlight and check both connectors.they should look silvery.
If they look black.take a thin flat blade screwdriver or an X-acto blade and scrape all around the male pins..as for the females, the only tool to get into those is a small drill bit.DO NOT spread the female pins, use a smaller bit than the hole if you have to and rub all around to loosen up any carbon. Blow it out, then reinstall the lamp..
If that doesn't fix it, TRY your old lamp if it still works, and see if it flickers..if not, then the NEW lamp may be defective.
Now, if both lamps flicker, you know the Lamps power supply needs replaced, and if you DON'T have that old lamp as a test, Call the place you got the lamp and get a swap..
remove the lamp and mak sure contacts are clean then try again
The answers post by the user, for information only, CeQnA.com does not guarantee the right.