Panasonic PT47WX53G backside projection tv shuts past its sell-by date on its own inside a minute and lead indicator flashes 3 times?
Answers: But that 80 dollars does apply to the repair if you authorize the repair....
The model number tell me the MOST LIKELY problem is the convergence amps since it takes almost a minute to shut down, but.....
It might be your vertical or horizontal circuit...those initiate a 3 blink downfall code too....
So I would suspect the convergence amps may cost about $380 for those or $320 for vertical /horizontal repairs.....
If you can afford those repair costs, it's worthwhile to attain the TV tech out to your home...
IF NOT, set it outside and tag it near "IT works -- Need Fixed"
It'll be gone in no time....
The TV go off but comes subsidise on
this means the horizontal sanctuary circuit
usually responsible for shut downs
is not at fault
if the horiz safekeeping trips you have to unplug the TV
to reset the shutdon status
I would start by verify your TV is plugged directly
into a wall plug
no extention cords and no surge protectors
If plugging into the wall stops the shutdowns then
jump out and replace what ever cord you were using
otherwise you involve a TV tech to look at the TV
the problem could be in lots places in the TV
convergence IC may be failing
135 volt supply to the horizontal sweep could be low
almost any low voltage supply could enjoy a cracked
solder connection cause random interuption
also I take back nuisence shutdowns with that Model
from the CPU PCB self loose
Left side of chassis all the track to front of PCB
its a small PCB that docks into signal main PCB
and it have 3 plugs that fit into sockets and it does
get loose over time (heating and cooling)
What I would do would be unplug the TV
afterwards remove and remount the CPU PCB
it was that simple
The answers post by the user, for information only, CeQnA.com does not guarantee the right.
Related Questions :